There is corrosion to the color steel plate wall, which affects the life of the partition wall. Therefore, the color-coated plate manufacturer recommends to make a 80-100mm high and 50mm wide civil structure cement foundation under the color steel plate partition wall when designing the car partition wall. Or special bricks, and then make color steel plates on them. If it is one side of the purification workshop, use the profile (large arc) specially designed and used by our company to ensure that it meets the requirements of the clean room, not the side of the clean workshop. Terrazzo and acid-resistant tiles are affixed to the top to ensure aesthetics.
Before using the color plate, check the integrity of the surface of the color plate. If the surface defect affects the appearance, it should be stored in another pile and properly protected for altruistic use. Uncover the protective film of the color board to the position where the rounded corners cannot be pressed; clean up the garbage on the ground, so that the garbage does not collect in the gap between the rounded corners and the ground, otherwise it will affect the overall appearance and indoor cleanliness. Fillet joints should be straight and uniform, with smooth transitions to 3D joints.
